- The front side body has a comprehensive Equal Pitched Rafter Table for determining layout of hip and valley roof systems with common pitches ranging from 2/12 to 18/12.
- The front side tongues have Unequal Pitch Rafter Tables for unequal roof systems ranging from 4/12 to 15/12 with a main common pitch of 12/12.
- The back side body has comprehensive Polygon Rafter Tables for 6 and 8 sided polygons.
- The backside tongues have Unequal Pitch Rafter Tables for unequal roof systems ranging from 4/12 to 15/12 with a main common pitch of 9/12.
Made of 13 gauge 304 stainless steel with deep etched rulings and tables, this square is built to last. The Master Framer, (Model #1824) has a body 2″ x24″ and a tongue of 1-1/2″ x 18″. The Traveler, (Model #1218) has a body 2″ x 18″ and a tongue of 1-1/2″ x 12″.
Cabinet Makers Bench Squares
2 The (Model #912-S) Center Square has a body 1-1/2″ x 12″ and a tongue 1″ x 9″. Both body and tongue front and back have conventional inch ruling on the edges and a center rule scale along the center of each leg.
Click on items or visit our Store to purchase
3 Center Rules are great for layout when working from center lines and for laying out detailed joinery. The Chappell Universal Center Rules are made from .029” stainless steel and are flexible enough to work on round logs and uneven surfaces. The front sides have decimal inch rulings as in all Chappell Universal products, with the rulings top and bottom starting from opposite zero points, allowing them to be worked from either side without flipping them over and reading upside down. Model CR118 has a Fraction to Decimal Conversion Chart and Trigonometric Ratio Equations etched on the front side. The backside is a center rule with edge rulings to allow both center work and zero point work on the same rule. Model CR112: 1” x 12” Stainless steel center rule Model CR118: 1-1/2” x 18” Stainless steel center rule